Why we obsess over the electrical guts of our IR lamps When you’re fabricating bio-sensors, your thermal profiles have to be spot on. Period....

If you’re running a Class 100 cleanroom, you already know the nightmare of a contaminated batch. One tiny bit of outgassing or a few stray...

Let’s Talk Electrical Safety for Wafer Curing Reflectors Wafer curing lamps are no joke. They deal with insane heat and high voltages that would make...

A Better Way to Heat Your Biosensors When you’re building biosensors, heat is a tricky beast. You need it to cure your polymers and get those...

Stop Wasting Your Heat: The Truth About Aluminum Reflectors In a smart Fab, heat is usually seen as a nuisance. But if you look at it differently,...

Why Quartz Shields are the Unsung Heroes of Your Fab Lamps If you’re trying to cut down on energy waste during heating and curing, you’ve...

Stop Worrying About Your Chemical Lines: The Truth About Ozone-Free IR Heating If you’re running cleaning lines with flammable solvents, a...

Keeping Your Cleanroom Actually Clean: The Truth About Infrared Heating If you’re running a Class 100 cleanroom, you already know the nightmare...

Keeping Your Class 100 Cleanroom Actually Clean When you’re working in a Class 100 environment, the last thing you need is your heating element...

Stop Waiting on Hot Air: Why We Switched to Gold-Coated IR If you’ve ever worked with hot air circulation, you know the drill. You heat the...

Making Sense of Carbon Fiber IR in the Modern Fab If you’re putting together a modern fab, you know that heat is a tricky beast. It’s not just...

Why We’re Switching to IR Curing in the Cleanroom If you’ve ever used a convection oven in a cleanroom, you know the drill. You’re...

Stop One Broken Lamp From Killing Your Whole Batch In a high-pressure fab, everything is going great until a single infrared lamp pops. Then,...

Introduction Let’s cut to the chase. We built this infrared heating lamp for one specific job: getting wafers dry, and done right. It gives you...

On the fab floor, a 0.5°C drift in the photoresist bake is enough to scrap an entire lot. We built our RTP lamp to take that uncertainty out of every...

On the fab floor, burn-in doesn’t mean a thing if the heat source wobbles. A few degrees of drift across the chuck and you’re masking marginal...

On the fab floor, a wafer dryer lamp dying at 3 a.m. isn’t “maintenance.” It’s a line stop. Soft bake and hard bake temperatures start to...

On the fab floor, you learn fast: a half-degree drift during the photoresist bake can shift critical dimensions by nanometers, and a single particle...